Front Door - Lamborghini Caloreclima MEGA Serie Manual De Instalación, Uso Y Mantenimiento

FRONT DOOR

For the MEGA models 92-1060, the door is hinged, fastened
and reversed as shown in the figure.
The following operations are required:
- The door is fitted with four equal hinges, the pins (pos. 3) are
inserted either on the right or the left of the support (pos. 1).
For the direction of opening, remove the pins on the right or
the left, and then fasten the door with the screws (pos. 6).
- Axial adjustments are possible by screwing in or loosening
the fastening nuts.
For MEGA models 1250-3600, the door is hinged, fastened and
reversed as shown in the figure.
The following operations are required:
- Unscrew the nuts (pos. 8) on the side that closes, and open
the door.
- Tighten the same nuts back onto on the corresponding bolts
but this time upside-down, and close the door again.
- Tighten the spare nuts (supplied with the boiler accessories)
in pos. 8, making sure they are fully tightened.
- Unscrew the nuts (pos. 7) corresponding to the part that acts
as a hinge.
- Open the door and unscrew the nuts (pos. 6).
- Close the door and use a pair of nuts (pos. 7), making sure
they are fully tightened.
- Finally, adjust the tightness of all the nuts so as to ensure per-
fect closing of the door; and then fasten the dowels (pos. 1).
1 Hinge support bracket
2 Hinge
3 Hinge pin
4 Fastening screw and nut
1 Fastening dowel
2 Hinge pin support nut
3 Hinge support ears
4 Hinge pin
5 Bolt welded to the pin
- 49 -
INSTALLATION
5 Bushing
6 Closing bolt and washer
6 Bolt-door fastening nut
7 Bolt-door fastening nut
8 Bolt-door fastening nut