Before Start Of Operation; Insert / Replace Battery; Preparing The Calliper; Starting Up The Device - Powerfix Profi HG00962A Instrucciones De Utilización Y De Seguridad

§ Before start of operation

Insert / replace battery

Q
Tip: Flashing numbers indicate a discharged / flat battery.
Tip: When changing the battery, the LCD display
experience faults. Remove the battery and insert it again after
waiting more then 30 seconds.
j
Push open the lid to the battery compartment
j
Remove the old battery.
j
Insert the new battery into the battery compartment and
ensure correct polarity (+ and -). Make sure that the plus
terminal points outwards.
j
Push the lid to the battery compartment
Fig. B).

Preparing the calliper

Q
j
Loosen the locking screw
calliper.
j
Clean all measuring surfaces and the calliper rod with a dry
cloth. Otherwise, faulty measuring results may occur due to,
for example, humidity.
j
Check that all keys, switches and the LCD display
correctly.
§ Starting up the device

Using the calliper

Q
j
Loosen the locking screw
j
Push the external measuring jaws
measuring jaws
j
Switch the LCD display
j
Press the inch / mm key
(inch or mm) you wish to use. Either "mm" or "in" will
appear to the right of the figures in the LCD display
j
Press the key to obtain the zero setting (ZERO)
to reset the LCD display
Measuring an object from the outside:
j
Move the external measuring jaws
handwheel
measuring jaws
together.
2
on by pressing the ON / OFF key
5
3
5
outwards anti-clockwise. Place the external
7
against the object to be measured.
11
so that you can move the
4
by turning it anti-clockwise.
4
and the internal
11
to set the unit of measurement
to zero.
apart by turning the
11
may
5
(see Fig. B).
8
shut again (see
8
work
5
5
in order
9
GB/IE 21
.
10
.