Replacing A Drive Belt; Maintenance And Cleaning; Service Centre; Warranty - Parkside PEH 30 A1 Instrucciones De Utilización Y De Seguridad

Preparing for use / Maintenance and cleaning / Service centre / Warranty
The planer blade has two cutting edges and it
20
can be fitted either way around.
Replace the planer blade
edges are blunt.
Do not resharpen the planer blades
Reversing or replacing a planer blade
IMPORTANT INFORMATION:
Do not release the two Allen keys. They are used to
adjust the height of the blade shaft.
Adjustment is necessary only if you wish to use a
different planer blade type e.g. a profiled blade.
Always replace both blades at the same time to
avoid out of balance forces.
NOTE: If you only release one blade first then you
can use the factory-fitted second blade for orientation
when you fit the new blade.
1. Release the 3 bolts of the cutting element
using the supplied open spanner
Press the removable side guard
in the housing.
2. Push the cutting element
the blade shaft 17
3. Push the planer blade
the cutting element
4. Reassembly is carried out in the reverse order
with a reversed or new planer blade.
5. Planer blades can be obtained from the
20
service address indicated (see section about

warranty).

©

Replacing a drive belt

(see Figs. F + G)
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Release the screws
cover .
4
Remove the worn drive belt
First place the new drive belt
belt wheel 25 and then pull the drive belt
on to the large belt wheel
42 GB/MT
20 when both cutting
.
20
.
26
into the slot
21
18 sideways out from
.
sideways out from
20
.
18
and remove the belt
5
.
23
on to the small
23
24 by rotating it.
Put the belt cover
fasten it into place with the screws
©

Maintenance and cleaning

20
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Always keep the device and the ventilation
slots clean. This way you will work more safely
and produce better results.
Clean out the planing debris removal port
regularly.
Clean out a blocked planing debris removal
port using suitable means (e.g. piece of wood,
air under pressure, etc.).
Use a dry cloth to clean the housing.
Remove any adhering planing dust with a
narrow paint brush.
In no circumstances use sharp objects, or petrol,
18
solvents or cleaning agents that might attack
plastic. Do not allow any liquids to enter the
inside of the device.
©

Service centre

only by qualified specialist personnel
using original manufacturer parts only.
This will ensure that your device remains safe
to use.
needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
© Warranty
The warranty for this appliance is for 3 years
from the date of purchase. The appliance
has been manufactured with care and me-
23
ticulously examined before delivery. Please
retain your receipt as proof of purchase. In
back into position and
4
5 .
DANGER OF INJURY!
Have your device repaired
If the plug or mains lead
3