Replacing The Drive Belt (See Fig. E); Maintenance And Cleaning; Disposal - Parkside PEH 30 C3 Traducción Del Manual De Instrucciones Original

♦ Replace the planing blade
edges are blunt.
♦ Do not try to sharpen the planing blade
Turn the planing blade
NOTE
► Do not undo the two hex socket screws.
These are used for adjusting the height of
the cutter block. Adjustment is only required
if you are using a different type of planing
blade, e.g. a rustic blade.
When changing the blade, always replace
both blades to prevent an imbalance.
► First, unscrew only one blade. This will allow
you to orient your self on the factory-mounted
second blade when reassembling later.
♦ Use the supplied open-ended spanner
undo the 3 fastening screws for the planing
blade .
♦ Push the movable cutter block guard
the slot in the housing.
♦ Push the clamping element
the cutter block .
♦ Remove the tensioning plate
ing element . Remover the planing blade
from the clamping element
♦ Fit either a new or turned blade in the reverse
order.
♦ Planing blades can be purchased from the
address given below (see section "Service").
Replacing the drive belt (see fig. E)
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
♦ Remove the screws
belt cover .
♦ Remove the worn drive belt
♦ Fit the new drive belt
wheel first and then turn the drive belt
and pull it onto the large belt wheel
│ GB │ IE
■ 20
when both cutting
.
or replace it.
to
into
upwards out of
from the clamp-
20a
.
and detach the drive
.
onto the small belt
.
♦ Replace the drive belt cover
place using the screws

Maintenance and cleaning

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
♦ Keep the appliance and the ventilation slits
clean to ensure fault-free operation.
♦ Clean the chip ejector
♦ To clean a blocked chip ejector, use a suitable
tool (e.g. a piece of wood, compressed air,
etc.).
♦ Use a dry cloth to clean the housing.
♦ Use a brush to remove any dust stuck to the
appliance.
♦ Never use sharp objects, petrol, solvents or
cleansers which can damage plastic. Do not
allow any liquids to get into the interior of the
appliance.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.

Disposal

The packaging consists of environmentally
friendly material. It can be disposed of in
the local recycling containers.
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
recycled in an environmentally compatible manner.
Your local community or municipal authorities can
provide information on how to dispose of the ap-
pliance.
and fix it in
.
regularly.
PEH 30 C3