Assembly - Outdoor Leisure TD125 Manual Del Propietário

Tools Required:
• 1) #2 Phillips Head Screwdriver
• 2) Adjustable Wrenches
Hardware packet provided with heater may
contain more parts than needed for heater

assembly.

1. Attach wheel assembly to base using two
5/16" bolts, two 5/16" washers and two
5/16" nuts (see Figure 1).
2. Attach legs to base using two 1/4" bolts,
four 1/4" washers, two 1/4" lock washers
and two 1/4" nuts per leg (see Figure
2). Place washer on bolt then insert bolt
through leg and into top of base. Attach
Figure 1 - Attaching Wheels to Base
1/4" Bolt
and Washer
Pole
Support
1/4" Washer,
Lock Washer
and Nut
Legs
Base
1/4" Washer,
Lock Washer
and Nut
Figure 2 - Base Assembly
121117-01C
aSSEMbLy
3. Secure pole support to legs using two
4. Remove 4 bolts and washers in collar of
5. Attach back cover using four 1/4" large
5/16" Bolt,
Washer
and Nut
Base
Wheel
Assembly
www.desatech.com
washer, lock washer and nut from under-
neath base. Finger tighten only. Repeat
for each bolt and leg. do not fully tighten
until next step.
1/4" bolts, four 1/4" washers, two 1/4" lock
washers and two 1/4" nuts per leg (see
Figure 2). Repeat for each leg. Wrench
tighten nuts and bolts from step 1 and 2.
pole support (see Figure 3). Place pole
over pole support collar. Reattach and
tighten 4 bolts and washers.
Phillips head screws and four 1/4" wash-
ers as shown in Figure 4.
Pole
Bolt and
Washer
Figure 3 - Pole to Pole Support
Figure 4 - Attaching Back Cover
Pole Support
Back Cover
1/4" Large
Phillips Head
Screw and
1/4" Washer
5