Servicing - MTD ALPHA95-165H Manual De Instrucciones

EN
Other indicators in the display
Brake / parking brake not actuated during
motor start attempt.
a) Mower not switched off during motor
start attempt.
b) OCR function was not activated prior to
mowing in reverse.
Operator not sitting on the driver's seat dur-
ing motor start attempt.

Servicing

Risk of injuries or material damage
¾ Only clean or service the device if the
motor is stationary.
¾ Remove the ignition key and the spark
plug connector.
¾ Wait until all moving parts have come
to a standstill and the motor has cooled
down.
¾ Never reach into the rotating cutting
blades.
¾ Only have repair and service work,
as well as the replacement of safety
elements, performed by a qualified
expert or workshop.
¾ Only have the replacement or
resharpening of the cutting blades
performed by a workshop.
¾ Clean the device and all add-on and
accessory parts after every instance of
use.
Cleaning the device
Attention!
¾ Do not use high-pressure cleaners for cleaning
the device.
Place the device on a solid and even foundation.
Î
Engage the parking brake.
Î
Clean the device with a brush, a hand brush or a
Î
cloth.
22
WARNING !
Cleaning the cutting mechanism
Sharp, moving cutting tools
ÂRisk of injury
¾ War safety gloves.
¾ Clean the cutting tools carefully.
¾ Ensure that the movement of one cutting
tools can lead to the rotation of another
cutting tool.
Attention!
Fuel may run into the combustion chamber.
ÂMotor damage
¾ Do not tilt the device more than 30°.
Bring the cutting mechanism into the highest posi-
Î
tion.
Clean the cutting area with a brush, a hand brush
Î
or a cloth.
Cutting mechanism with cleaning nozzle
(optional) W
Cleaning
Place the device on a clean, solid foundation.
Î
Engage the parking brake.
Î
Attach a water hose with a standard quick cou-
Î
pling to the cleaning nozzle.
Start the motor.
Î
Lower the cutting mechanism and switch it on.
Î
Let the motor and cutting mechanism run for a few
Î
minutes.
Switch the motor and cutting mechanism off.
Î
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Bring the cutting mechanism into the highest posi-
Î
tion.
Start the motor and switch on the cutting mecha-
Î
nism.
To dry the cutting mechanism, let the motor and
Î
cutting mechanism run for a few minutes.
Switch the motor and cutting mechanism off.
Î
DANGER !
Servicing