Operating Elements; Putting Into Use; Operation - MTD ALPHA95-165H Manual De Instrucciones

EN

Operating elements

Overview A
A Ignition lock (model-dependent)
1 Ignition lock with key for turning
2 Ignition lock with key for pressing (also with a Bluetooth
service function on certain models)
B PTO switch (model-dependent)
C Forward-drive pedal
D Reversing pedal
E Cutting height adjustment lever
F Gear release lever
G Discharge chute
H Fill level sensor for grass collector (model-dependent)
I Trailer coupling
J Battery compartment
K Seat adjustment lever
L Storage compartment with cup holder, dependent on model
with optional 12 volt socket
M Pedal for differential lock (model-dependent)
N Switch for parking brake / cruise control
O Indicator panel (model-dependent)
P Choke (model-dependent)
Q Braking pedal
R Tank level indicator
S Throttle / choke (model-dependent)
T Fuel tank
U Steering wheel (not visible)

Putting into use

Prior to each operation
Check:
• All protective equipment
• Motor oil level (see motor manual)
• Tank fill level
• Tyre pressure
• Side coverings, add-on devices, air filter area
for damage and mowing residue
Checking the tank and oil level
Note
The motor is already filled with oil at the fac-
tory. Please check and top up if necessary.
• Refuel with unleaded petrol P .
• Fill the fuel tank to a maximum of 2 cm below
the bottom edge of the filler neck.
• Seal the fuel tank shut tightly.
• Check the oil level T . The oil level must be
between the "Full/Max" and "Add/Min" markings
(also refer to the motor manual).
16
Checking tyre pressure
Note
For reasons of manufacture, tyre pressure
may be higher than required.
Check tyre pressure and correct it when required.
Î
Front 0.9 bar
Rear 0.7 bar
Adjusting the driver's seat L
Pull the lever and adjust the seat La .
Î
or
Release the adjusting screw, set the seat and
tighten the adjusting screw once again Lb .
Adjusting the cutting mechanism wheels U
The cutting mechanism wheels must be at the
lowest cutting mechanism setting, always at least
6–12 mm above the ground. The cutting mechanism
wheels are not designed to bear the weight of the
cutting mechanism. They are merely designed to
compensate for bumps in the ground.
Always space the cutting mechanism wheels
Î
evenly.

Operation

Attention!
¾ Also pay attention to the notes in the operating
instructions for the motor.
Note
Pay attention to national / municipal regula-
tions governing hours of use; enquire at your
local authority if necessary.
Engaging / disengaging the parking
brake A N
To engage the parking brake, step down fully on
Î
the brake pedal A Q and press the switch N .
To disengage the parking brake, step on the brake
Î
pedal A Q until the switch N is released.
Attention!
¾ Always engage the parking brake before leaving
the device.
Operating elements