Machine Information - Ferm HDM1028 Traducción Del Manual Original

Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important
that it is correctly destroyed and replaced by
an approved BS1363/13A fused plug and that
the following wiring instructions are followed.
h the The wires in the mains cable are coloured in
accordance with the following code:
• b lue
• b rown
otary
As the colours of the wires in the mains cable
of the unit may not correspond to the coloured
e can markings identifying the terminals in the plug,
proceed as follows:
• T he wire which is coloured blue must be
th the connected to the terminal which is marked
al injury. with the letter N or coloured black.
• T he wire which is coloured brown must be
g connected to the terminal which is marked
tion with the letter L or coloured red.
ntact
g Use of extension leads
make Only ever use approved extension leads that are
live" suitable for the power rating of the machine. The
shock. minimum core thickness is 1.5 mm
using a reel extension lead, always fully unroll the
lead.
erve the
ry to Immediately switch off the machine when:
ersonal • E xcessive sparking of the carbon brushes.
ns and • I nterruption of the mains plug, mains lead or
mains lead damage.
• D efect switch.
he • S moke or stench of scorched isolation.
voltage

2. MACHINE INFORMATION

on - You
Intended use
This rotary hammer is intended for drilling holes
in masonry such as brick, concrete and similar
n is material. Furthermore, the machine can be used
(RCD) as a demolition hammer in combination with the
the risk SDS cold chisels provided. The machine is on no
account intended for other purposes.
eplaced
milarly
d.
HDM1028 Ma 1611-07.indd 5
neutral
live
. Whenever
2
Not suitable for construction site usage
Technical specifications
Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. Drill diameter
-Concrete
-Steel
-Wood
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration
Hammer drilling concrete a ,
h HD
Chiseling a
h,Cheq
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745. It may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• U sing the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• T he times when the tool is switched off or
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm and organizing your work
patterns.
230-240 V ~
50 Hz
850 W
900 /min
4000 /min
Ø 26 mm
Ø 13 mm
Ø 40 mm
4.6 kg
87.9dB(A)
K=3 dB(A)
98.9dB(A)
K=3 dB(A)
17.812m/s
2
K=1.5m/s
2
16.377 m/s
2
K=1.5m/s 2
5
23/11/16 16:35