Scan Mode - Leica RANGEMASTER 2700-B Manual De Instrucciones

SCAN MODE

6 1 6 3
7 2
The Leica Rangemaster can also be used for continu-
ous measurements (scan mode):
Press and hold the main button 2 at the 2nd press.
After around 2.5 seconds, the device switches to scan
mode and then carries out continuous measurements.
This can be seen by a change in the display. Around
every 0.5 seconds, a new measured value is shown.
Scan mode is particularly useful for measuring the
range to small or moving targets.
Notes:
• In scan mode, the
AbC
p. 45) is displayed after the last measurement.
• Because of the continuous measurements, power
consumption is greater in scan mode than for single
measurements.
compensation value (see
EN
45