Ordering Spare Parts; Technical Specifications; Putting The Machine Into Service; Instructions For Use - Grillo DUMPER 406 Manual De Instrucciones

Translation of the original instructions

ORDERING SPARE PARTS

Always state the machine serial number and the code number of the part to be replaced.
Contact your local dealer. Our address is:
GRILLO S.p.A.
Via Cervese 1701 - 47521 CESENA (FC) - ITALY
Tel. 0039 / 0547 / 633111 - Fax 0039 / 0547 / 632011
Web site: www.grillospa.it - E-mail: [email protected]

TECHNICAL SPECIFICATIONS

ENGINES:
– HONDA GX200 196 cc, 5,5 HP (@ 3600 r.p.m.) 4-stroke one cylinder petrol engine.
– KOHLER 3000 196 cc, 5,5 HP (@ 3600 r.p.m.), 4-stroke one cylinder petrol engine.
STARTER: with recoil starter.
FUEL TANK: 3,6 litres.
CLUTCH: per belt tension.
GEARBOX: gears in oil bath with 6 speeds: 3 forward speeds + 3 reverse speeds.
SPEED: I km/h 1 - II km/h 2 - III km/h 3.5 – I-R km/h 1 – II R km/h 2 – III R km/h 3.5.
DRIVE: rubber tracks with inner steel links.
STEERING: with clutches in oil bath combined with brakes.
LOAD BED: 1000×655×200 mm (height 33 cm with top extension sides). With side dump boards through gas spring.
OVERALL HEIGHT WITH LOAD BED: 43,5 cm.
LOAD CAPACITY: 400 kg.
SECURITY DEVICES: automatic handbrake.
TRACK BEARING SURFACE: 70 cm.
TRACK EXTERNAL BULK: 65 cm.
WEIGHT: 267 kg (with Kohler 3000) - 268 kg (with GX200)

PUTTING THE MACHINE INTO SERVICE

1) Check that the machine has not been damaged during transport.
2) Check the engine oil level.
3) Fill the tank with fuel using a funnel with a very fine filter.
4) All checks have to be carried out with the machine in horizontal position.
5) Check the tension of the tracks (fig. 6). If necessary increase their tension by loosening the counter-nut and then
fastening the bolt.
6) Check that the steering levers are working properly.
7) Check that the load body is firmly secured.

INSTRUCTIONS FOR USE

STARTING THE ENGINE
After making the checks described:
Bring the hand throttle lever (4, fig. 1) to the midway position and engage the choke (10, fig. 1). Start the engine by
pulling the pull-start knob sharply (9, fig. 1).
After the engine has started, disengage the choke (10, fig. 1) and gradually return the throttle close to the idling
position.
Allow the engine to warm up for a few minutes before starting work, and to allow proper running-in do not force the
machine excessively during the first 50 hours of use.
STARTING THE PETROL ENGINE
1) Open the fuel tap (fig. 10, n. 1)
2) Push throttle lever halfway (fig. 1, n. 4)
3) Engage the choke device if the engine is cold (fig. 1, n. 2).
Engine with recoil starter:
- Make sure the button placed on the engine is in "ON" position (fig. 11, n. 1)
- Start the engine by strongly pulling the knob (fig. 10, n. 3).
7