Temperature Setting; Fan Speed Setting; Navigating Through The Main Menu - Mitsubishi Electric Mr.Slim SLZ-KA25VAQ3 Manual De Instrucciones

3. Operation
3.3. Temperature setting
<Cool, Dry, Heat, and Auto>
Fri
Room
Cool Set temp.
Mode Temp. Fan
F1 F2 F3 F4
Press the [F2] button to decrease the preset temperature, and press the
[F3] button to increase.
• Refer to the table on page 6 for the settable temperature range for
different operation modes.
• Preset temperature range cannot be set for Fan/Ventilation operation.
• Preset temperature will be displayed either in Centigrade in 0.5- or
1-degree increments, or in Fahrenheit, depending on the indoor unit
model and the display mode setting on the remote controller.
3.4. Fan speed setting
Fri
Room
Cool Set temp.
Mode Temp. Fan
F1 F2 F3 F4
Press the [F4] button to go through the fan speeds in the following order.
• The available fan speeds depend on the models of connected indoor
units.
Note:
The number of available fan speeds depends on the type of unit
●
connected.
In the following cases, the actual fan speed generated by the unit
●
will differ from the speed shown the remote controller display.
1. W hile the display is in "STAND BY" or "DEFROST" states.
2. W hen the temperature of the heat exchanger is low in the heat-
ing mode.
( e.g. immediately after heating operation starts)
3 In HEAT mode, when room temperature is higher than the tem-
perature setting.
4. W hen the unit is in DRY mode.
3.5. Airflow direction setting
3.5.1 Navigating through the Main menu
<Accessing the Main menu>
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
Fri
28.5
Room
Cool Set temp.
28.5
Mode Temp. Fan
Example display
(Centigrade in 0.5-degree increments)
Press the [MENU] button.
The Main menu will appear.
<Item selection>
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Cursor
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
<Navigating through the pages>
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
<Saving the settings>
OU silent mode
Mon Tue Wed Thu Fri Sat Sun
Start Stop Silent
-
Setting display:
day
F1 F2 F3 F4
<Exiting the Main menu screen>
Fri
Room
Cool Set temp.
Mode Temp. Fan
F1 F2 F3 F4
If no buttons are touched for 10 minutes, the screen will automatically
return to the Main display. Any settings that have not been saved will
be lost.
<Display of unsupported functions>
Title
Not available
Unsupported function
Return:
F1 F2 F3 F4
Press [F1] to move the cursor down.
Press [F2] to move the cursor up.
page
Press [F3] to go to the previous page.
Press [F4] to go to the next page.
Select the desired item, and press
the [SELECT] button.
The screen to set the selected item
will appear.
Press the [RETURN] button to exit
the Main menu and return to the
Main display.
The message at left will appear if the
user selects a function not supported
by the corresponding indoor unit
model.