Storage; Disposal And Recycling - Scheppach MFH5200-4P Traducción De Las Instrucciones Originales De Funcionamiento

Grass trimmer/brush cutter:
Spool with Ø 450
Blade with 3 teeth Ø 255 x 1.4
Transport guard for blade 3 teeth
Blade with 4 teeth Ø 255 x 1.5
Transport guard for blade 4 teeth
Blade with 8 teeth Ø 255 x 1.5
Transport guard for blade 8 teeth
Safety shield for grass trimmer
Pole pruner:
Saw chain Oregon 91PJ040X
Guide rail Oregon 100SDEA318
Transport guard for chain
Extension for pole pruner
Hedge trimmer:
Blade for hedge trimmer 400 mm
Transport guard for blade

11. Storage

Cleaning
• Keep handles free of oil, so you always have a se-
cure hold.
• Clean the equipment as required with a damp cloth
and, if necessary, mild washing up liquid.
m Important!
• Always pull out the spark boot plug each time be-
fore carrying out any cleaning.
• Never immerse the equipment in water or other liq-
uids in order to clean it.
• Store the petrol multi garden tool in a safe and dry
place out of the reach of children.
Storage
Important: Never put the equipment into storage for
longer than 30 days without carrying out the follow-
ing steps.
Storing the equipment
If you intend to store the equipment for longer than 30
days, the equipment must be prepared accordingly.
Otherwise the fuel still remaining in the carburetor will
evaporate and leave a rubbery sediment. This can
cause problems when starting up the equipment and
may require expensive repairs.
1 Slowly remove the fuel tank cap to release any
pressure that may have formed in the tank. Care-
fully empty the tank.
2 To remove the fuel from the carburetor, start the
engine and let it run until the equipment stops.
3 Leave the engine to cool (approx. 5 minutes).
4 Remove the spark plug (see section 10 Change
and clean the spark plug).
5 Add one teaspoon of 2-stroke engine oil into the
combustion chamber. Slowly pull the starter cord
several times to apply a layer of oil to all internal
components. Fit the spark plug again.
Note: Store the equipment in a dry place and far
7910700706 away from possible ignition sources such as an oven,
7910700702 a gas-fi red hot water boiler, a gas-fi red dryer, etc.
3904801065
7910700705 Putting the equipment back into operation
3904801066 1 Remove the spark plug (see section 10 Change
7910700711
3904801066 2 Quickly tug on the starter cord to remove excess
3904803034
3 Clean the spark plug and check that the electrode
7910700704
3904801037
3904801039 4 Prepare the equipment for operation.
7910700710 5 Fill the tank with the relevant mixture of fuel and
7910700703
3904801043 Transport
To transport the machine, empty the petrol tank as
described in section 8 draining fuel. Clean coarse dirt
off the equipment with a brush or hand brush.
Always attach the transport guard to all cutting tools.
Fig. 1 (14a, 15a, 17a)
In order to prevent damage and injury, secure the tool
against tipping over and sliding when transporting it
in vehicles.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
and clean the spark plug).
oil from the combustion chamber.
gap is correct, or insert a new spark plug with the
correct electrode gap.
oil. See the section „Fuel and oil".
GB 41