Troubleshooting - Husqvarna JONSERED LR 2107 C Manual De Uso

ROUTING BELTS (starts at page 124)
Q
Only use genuine parts see below. Failure to use genuine parts could
result in malfunction or damage to the tractor.
Always use original belt.
- Check with an Authorized Service Dealer for Repair Parts.
Drive belt - Style AX - 32 1/4"K - Kevlar
Cutting Deck Belt - 4H400

TROUBLESHOOTING

FAULT
Engine does not start
Engine stalls
Poor cut
Grass bag fails to fill
The unit does not drive
Cutting deck does not function Cabling defect
POSSIBLE CAUSES
No petrol
Poor contaminated petrol
Dirty engine air filter
No spark
Difficulty in starting, flooded engine.
Flat battery
Starter cord incorrectly connected
Intervention of safety devices
Grass too high or damp.
Mower casing blocked
Dirty air filter
Carburetor calibration incorrect
Blunt blade
Blade badly worn
Incorrect cutting height
Grass too heavy or too damp to be conveyed by the air
stream
Blade badly worn, blunt
Grass is too high causing poor collection.
Casing blocked with previous grass cutting
Drive belt detached
Defective transmission
Clutch damage
Faulty belt
Bag is not installed properly
1 - If the deck or drive belt come off the pulley, please see the diagram to
correctly reroute the belt.
2 - Before servicing the belts shut off engine, apply parking brake, and lower
deck to lowest height cut. Wait for engine to cool.
Fill the petrol tank with unleaded petrol
Always use clean, fresh petrol. Only use unleaded petrol.
Clean the engine air filter according to engine manufacturer's guidelines and
instruction manual.
Clean the spark plug and replace if necessary, according to engine
manufacturer's instruction manual.
Unscrew the plug and dry it. Follow engine manufacturer's guidelines and
instruction in manual. Let the unit sit for a few minutes.
Recharge.
Check the connection.
Check the correct operation of the devices (see point L)
Raise the cutting lever to maximum height. Slow ground speed, or wait for
grass to dry.
Clean the casing (Important: before cleaning extract the spark plug lead)
Clean air filter (see engine instructions also).
Take unit to Authorized Service Dealer for assistance.
Take unit to Authorized Service Dealer to replace the blade.
Take unit to Authorized Service Dealer to replace the blade.
Take unit to Authorized Service Dealer to replace the blade.
Wait until the lawn surface has dried off.
Replace the blade.
Cut the lawn twice, altering the cutting height accordingly.
Clean the casing (do not use water)
NB: remember to remove the spark plug connector.
See belt routing diagram page 124
Seek assistance from Authorized Service Dealer.
Seek assistance from Authorized Service Dealer.
Seek assistance from Authorized Service Dealer.
Seek assistance from Authorized Service Dealer.
Properly install bag and check fit up
27
ENGLAND
CORRECTION