Configuring The Hardware; Connecting To The Csnet Web Interface - Hitachi CSNET WEB Manual De Instalación Y Funcionamiento

CSNET WEB
Installation & Operation Manual
5. Configuring the Hardware
After completing and checking the electrical installation, ensure
that all the air conditioning units are running, and supply power
to CSNET WEB in order to configure the CSNET WEB interface
1. Connect the computer that will be used for configuration to
CSNET WEB with a crossed Ethernet cable.
2. Insert the CD-ROM that is supplied with the CSNET WEB
package into the computer that is already connected. If
the Windows auto-start option is enabled, the installation
programme will start automatically; if this option is not
enabled, execute the Autoinstall.exe application that is
included in the CD-ROM.
3. The initial page for the installation, "CSNET WEB Hardware
& Software Setup", will be displayed with the following three
options:
 Configure CSNET WEB Hardware (Change Network
Settings): Change CSNET Web's TCP/IP configuration in
order to adapt it to the network where it will be installed.
 Connect to CSNET WEB Software for Configuration:
Connect to the CSNET WEB application in order to
configure all the points that are explained in the following
chapters.
 Install CSNET WEB software and direct access in your
PC: to install the CSNET WEB application on our PC, and
afterwards on the computers in the same network that will
use CSNET WEB.
 Update CS NET WEB Hardware: this permits remote
updating of the firmware of the CSNET WEB interface.
5.1. Connecting to the CSNET WEB
interface.
1. Select "Configure CSNET WEB Hardware (Change
Network Settings" and the "Select Network Card" screen
will be displayed showing the different network adapters
available on the PC.
2. Select the network adapter that you will use and click "Next".
3. The "CSNET WEB Hardware Settings" screen will be
displayed in order to change CSNET WEB's TCP/IP
configuration.
The "Installer" password will be required in order to configure
CSNET WEB. Initially, the password is "Installer"; it can be
changed afterwards. Enter this password in the "INSTALLER
PWD" field.
The HW IP ADDRESS, HW NETMASK and HW GATEWAY
fields must be the configuration parameters required
for CSNET WEB; they will be provided by the network
adminstrator.
Click "Next" to continue.
Page 6
PMML0163A-rev.0 - 03/2008
< Back Next > Cancel
< Back Next > Cancel
< Back Next > Cancel