Updating The Csnet Web Hardware; Installing The Csnet Web Software, And Direct Access In Your Pc - Hitachi CSNET WEB Manual De Instalación Y Funcionamiento

CSNET WEB
Installation & Operation Manual
3. Introduce the IP of the CSNET WEB you want to connect
to. The configuration you have already chosen appears by
default. You should always introduce the temporary IP the PC
has to use.

Warning:
If the PC and CSNET WEB interface are connected to a
local area network, the network configuration should be
supplied by the network administrator. Otherwise, use a
valid configuration within the range set for the CSNET
WEB interface.
In case of doubt, consult the network administrator.
4. Press Next to validate the changes, change the PC network
configuration temporarily and start the CSNET WEB
application which configures the system.
5. When the application starts it configures the system as
indicated in chapter 4.
6. After completing the configuration close the CSNET WEB
application and choose Accept in the message Waiting for
CSNET WEB to finish.... The installation will return to its
initial screen.
5.3. Updating the CSNET WEB
hardware
This option permits updating of the firmware of the CSNET
WEB.
1. Select "Update CSNET WEB hardware" and press next.
2. Press "Install". In a few seconds the CSNET WEB update
program will open.
3. Enter the installer's password, by default "Installer", in the
Installer Password field. Enter IP address or the CSNET
WEB network name in the "Address" field.
4. Press "Update". After a few minutes the progress bar will
indicate that the process has ended (the time will depend on
the speed of the connection with CSNET WEB).
5. Close the update software by pressing "Close".
6. Press "Next" to return to the beginning of the CSNET WEB
installation or cancel to exit.
Page 8
PMML0163A-rev.0 - 03/2008
< Back Next > Cancel
OK
< Back Next > Cancel
< Back End > Cancel