Initial Configuration - Hitachi CSNET WEB Manual De Instalación Y Funcionamiento

CSNET WEB
Installation & Operation Manual
6.2. Initial Configuration
Before using CSNET WEB, you must correctly configure the
different areas of the screen, as shown below.
1
5
4
6
1 Area tree: Permits a conceptual ordering of the units. It can
be organized into as many groups as you want. The root will
always be Installation, and the indoor areas and units will be
joined to this node.
2 Table of indoor units: List of all the indoor units with the
basic information about their state of operation.
3 Operation panels: Control area for the operation of units.
Area tree

"Enable Area Edition" activates an area tree for this installation.
- New:Creates a new area
- Edit: Edits the selected area in the area tree
- Delete: Deletes the selected area
- Up: Moves the selected area up, respecting its level
- Down: Moves the selected area down, respecting its level
- Update: Saves all the areas created and closes the Area
Edition
- Cancel: Closes the Area Edition without saving changes
made.

Note:
The areas created contain indoor units. See the following
chapter if you want to select to which area each of the
units belongs.
Page 13
PMML0163A-rev.0 - 03/2008
4 Configuration and file view: Gives access to the
configuration of CSNET WEB and to Historical Data and
Power Consumption files.
5 Edition of area tree:Allows you to edit the Area Tree
6 HARC-WEB Status: show current state of four HARC-WEB
connections.
2
3