Troubleshooting - Braun iCheck 7 BPW 4500 Manual De Instrucciones

• When the unit is not going to be used for a long time, remove the batteries. (Batteries may leak
or cause damage).
• Do not modify the device. NEVER open the device! This will void the manufacturer's guarantee.
Calibration
This device was calibrated at the time of manufacture. If used according to the instructions
for use, periodic recalibration is not required.
Guarantee
Please read all instructions before attempting to use this device. Please retain the receipt as
proof/date of purchase.
The receipt must be presented when making any claim within the relevant guarantee period.
Any claim under the guarantee will not be valid without a proof of purchase.
Your device is guaranteed for Two Years (2 Years) from date of purchase.
This guarantee covers defects in materials or workmanship that occur under normal use,
defective devices meeting these criteria will be replaced free of charge.
The guarantee DOES NOT cover defects or damage resulting from abuse or failure to follow
the user instructions.
The guarantee becomes void if the device is opened, tampered with, or used with none
Braun branded parts or accessories, or if repairs are undertaken by unauthorised persons.
Accessories and consumables are excluded from any warranty.
For support requests, please visit www.hot-europe.com/support or find service contact
information at the end of this owner manual.
This guarantee is applicable to Europe, Middle East and Africa only.
The LOT and SN of your device are printed on the rating label located inside the battery
compartment.
UK Only: This does not affect your consumer statutory rights.
8

Troubleshooting

Problem Reason
Low battery warning
Empty battery warning
Device does not turn on,
Problem with batteries
screen is black
Cannot connect to
"ERROR "
Smartphone
Measuring error
"ERROR 0"
The pulse signals on the cuff
are too weak
Pumping error
"ERROR 1"
The cuff is not fastened
properly
"ERROR 2" Out of Range Results Error
Pump time error
"ERROR 3"
The cuff is not fastened
properly
User could not find the
"ERROR 4" correct wrist position (angle)
in less than 60 seconds
"ERROR 254" Device internal error
"ERROR 255" Calibration error
An error occurred during the
"ERROR 256"
Bluetooth Firmware update
English
Solution
Be ready to replace batteries with new ones soon.
Insert new batteries or check that batteries are correctly
inserted.
Change batteries for new ones and make sure to insert them
correctly. If problem persists, contact consumer support
Stay away from radio interference such as microwave ovens,
WiFi routers, laptop computers, etc. Make sure Bluetooth
is enabled on your Smartphone before starting the pairing
sequence.
Follow the instructions for Bluetooth pairing in the
Braun APP and re-initiate the Bluetooth pairing sequence
using the Braun APP.
Reposition the cuff and repeat the measurement.
Reposition the cuff, close it tighter then repeat the
measurement.
Relax for a while and repeat the measurement.
Make sure the cuff is correctly positioned on your arm.
Re-fit the cuff, and take a measurement again.
Position the wrist at heart level as indicated by the 'Easy
Positioning System' .
Remove and then reinsert the batteries. If the problem
persists, contact consumer support.
Remove and then reinsert the batteries. If the problem
persists, contact consumer support.
Device will automatically restart using the original Bluetooth
firmware. Re-initiate the firmware download process or follow
the on-screen instruction from Braun APP.
9