Using The Unit - Clatronic BS 1215 Instrucciones De Servicio/Garantía

29782-05-BS 1215
* Push the vacuum hose into the opening of the dustbag compartment until it
clicks in mechanically. In order to remove the hose again, press the two clamps
inwards while pulling at the same time.
* Put the suction tube or other accessory onto the handle
1. Install the accessory. Adjust the telescopic tube as necessary.
2. Unwind the necessary amount of cable, put the mains plug into a 230 V, 50 Hz
mains socket and switch the unit on.
3. Set the vacuum strength with the suction strength controller.
4. Start vacuuming at a constant speed. It is not necessary to press. Check that
you have not come to the end of the cable.
Suction control (click-stop settings):
Low suction strength: for curtains and delicate materials
Medium suction strength: for deep-file velvet carpets and delicate carpeting
High suction strength: for ordinary carpets and floors.
Telescopic vacuum tube:
This allows the unit to be matched to your size. Adjust it by pressing the knob on
the tube and pulling the two tubes apart.
Accessory compartment:
Pull the edge of the lid over the suction tube connection upwards and fold the lid
up. The brush and crevice nozzles are located here. The brush nozzle can also be
used without the brush as a nozzle for large surfaces. In order to assemble the
brush insert the long edge into the plug-in tube and press on the other end of the
brush until a click is heard.
Winding device for the power cable:
Unwinding: Pull out the length that you require. The maximum length is shown by a
marking on the cable. Do not pull any further! The winding device could be dama-
ged otherwise.
Winding in: Hold the cable firmly to prevent it from whipping around. Press the but-
ton for cable winding and guide the cable in.
04.12.2002 14:07 Uhr
Startup

Using the unit

Seite 23
GB
23