Remote Control Preparation; Basic Operation: Preparations; Basic Play; Standby - Clatronic DVD 569 HC Instrucciones De Servicio

DVD 569 HC - GB 28.08.2003 10:52 Uhr

Remote control preparation

Battery installation (A)
Insert the batteries while observing the correct (+) and (-)
polarities as illustrated.
Service life of batteries
• The batteries normally last for about one year
although this depends on how often and for what
operations the remote control is used.
• If the remote control unit fails to work even when it is
operated near the player, replace the batteries.
• Use 2 x 'AA' type batteries.
Notes:
• Do not use rechargeable (Ni-Cd) batteries.
• Do not attempt to recharge, shot-circuit or disassem-
ble batteries. Never place batteries close to a heat
source such as radiators or heaters.
• Dispose of batteries in a responsible manner. Never
throw batteries on a fire.
• Do not drop or step on the remote control unit. This
may damage the parts or lead to malfunction.
• Do not mix old and new batteries.
• If the remote control unit is not going to be used for
long time, always remove the batteries to prevent
leakage.
26
Seite 26
REMOTE CONTROL
SIGNAL SENSOR
Remote control operation range (B)
Point the remote control unit no more than about 7 m
from the remote control sensor and within 60° from the
front of the unit.
• The operating distance may vary according to the
brightness of the room.
Notes:
• Do not point bright lights at the remote control sensor.
• Do not place objects between the remote control unit
and the remote control sensor.
• Do not use this remote control unit while
simultaneously operating the remote control unit of
any other equipment.
Basic operation
Preparations
• Connect to the TV set, turn on the POWER and set
the TV/AV switch of TV to AV mode

Basic play

1. Press POWER SWITCH button by the back-cabinet
unit to switch on the power. VFD display "DVD". The
unit is in DVD play mode.
2. Press OPEN/CLOSE button by the front-cabinet unit
or remote control unit to open the disc tray.
3. Place a disc onto the disc tray. Hold the disc without
touching either of its surfaces, position it with the
printed side facing up, align it with the guides and
place it on the disc tray.
4. Press the OPEN/CLOSE button again or PLAY on the
front-cabinet unit or remote control will close the disc
tray and playback.
• If the disc is a DVD, the player will automatically play.
• If the disc is a CD, the player will automatically play.
• In case of interactive DVDs with playback control, a
menu screen appears on the TV, with DVDs, you can
use CURSOR to select which item you want to enjoy
and press ENTER key.

STANDBY

Press STANDBY button on the front-cabinet or the remo-
te control unit to switch the unit from ON to STANDBY
mode. In standby mode, the unit is still consuming a small
amount of power. Press STANDBY button again for resu-
me the unit.
Note:
• The disc continues to rotate while the menu is display-
ed even after the player has finished playing a particu-
lar item. When no further selections are to be played,
be sure to press the STOP button to clear the menu
display.
• If the disc is placed in the tray upside down (and it is a
single sided disc), the DVD display will indicate "NO
DISC".
For your reference:
When appears while a button is being operated, it me-
ans that the corresponding operation is prohibited by the
player or the disc.