Connection To The Speaker System; Connect To Other Av Equipment; Headphone Connection; Installation Of The Surround Loudspeakers - Clatronic DVD 569 HC Instrucciones De Servicio

DVD 569 HC - GB 28.08.2003 10:52 Uhr

Connection to the speaker system

Connect a
Front L speaker
Front R speaker
CENTER speaker
SURROND L speaker
SURROND R speaker
SUBWOOFER speaker
NOTE:
• This unit should connect to speaker system with
8Ω impedance and the maximal power 10 W
except that SUBWOOFER connects to speaker
with 6Ω and the maximal power of every speaker
should not less than 30 W.
• Connect "+" terminal (red) of the speaker to "+"ou-
tput terminal (red) of this unit. Connect "–" termi-
nal (black) of the speaker to "–"output terminal
(black) of this unit.
• Connect the terminal wire tightly to prevent sever-
al copper wire leave out to create short circuit.
• Shut down the power of this unit before
connecting the speaker system.

Connect to other AV equipment

• When other AV signal source are necessary to
connect to this unit, use video cable (yellow) and au-
dio cable(red and white) to connect the video output
terminal and audio L ,R output terminal of other AV
equipment such as VCR ,CAMERA to AUX1 V1/R1/L1
input Jack or AUX2 V2/R2/L2 input Jack of this unit.
• When needing to rebroadcast or record AV signal of
this unit, please connect the video input terminal and
audio L, R input terminal of rediffusion or record
equipment such as Amplifier ,VCR to AV V/R/L output
Jack of this unit.
• When this unit is needed to output digital audio signal
to other equipment to record or play, connect the
coaxial or optical input terminal of other equipment to
coaxial or optical output Jack of this unit with coaxial
or optical connection cable.
• When digital audio signal of other equipment is
needed to input this unit to play, connect coaxial or
optical output terminal of other equipment to coaxial or
optical input jack(7.17)of this unit with coaxial or opti-
cal connection cable.

Headphone connection

The "PHONES" socket is suitable for all commercially
available headphones with a 3.5 millimetre jack plug. For
other plugs it is possible to buy the corresponding adap-
ters in specialist shops.
Seite 25

Installation of the Surround Loudspeakers

to the 1. Pass the loudspeaker cable through the mounting de-
FL Jack
FR Jack
C Jack
SL Jack
SR Jack
SW Jack
2. Position the loudspeaker on the holding device and fix
3. Now pass the loudspeaker cable through the upright
vice as shown in illustration A. Please allow 100 mm
of the cable to protrude out of the holding device.
Holding device
it in place with the screw - see illustration B.
Holding device
tube and place the holding device on top as shown in
illustration C.
Holding device
Upright tube
25