Tabla de contenido
Idiomas disponibles
Idiomas disponibles
In order to ensure safe operation of the spray gun, the safety regulations listed below
must be followted:
1.
Read all instructions and safety precautions before operating equipment.
2.
Never spray near sources of ignition; e.g. open flames, cigarettes — also cigars and pipes are
sources of ignition —, sparks, hot wires and hot surfaces, etc.
3.
Wear respiratory equipment when spraying. The operator must be provided with a protective
mask.
In order to prevent work related illness, the manufacturer's regulations for the materials,
solvents, and cleaning agents used must be observed when preparing, working with and
cleaning the unit. Protective clothing, gloves, eyewear, and, in certain cases, protective skin
cream are necessary to protect the skin.
4.
Follow the coating material and solvent manufacturer's warnings and instructions.
5.
Extraction equipment should be installed by the user in accordance with local regulations.
6.
The objects being sprayed must be earthed.
7.
Before each use, check all hoses for cuts, leaks, abrasion or bulging of cover. Check for
damage or movement of couplings. Immediately replace the hose if any of these conditions
exist. Never repair a paint hose. Replace it with another grounded high-pressure hose.
8.
Pulling the trigger causes a recoil force to the hand that is holding the spray gun.
The recoil force of the spray gun is particularly powerful when the tip has been removed and
a high pressure has been set on the airless high-pressure pump. Therefore, when cleaning
without tip set the pressure control valve to the lowest pressure.
9.
Use only manufacturer authorized parts. User assumes all risks and liabilities when using
parts that do not meet the minimum specifications and safety devices of the spray gun
manufacturer.
Specifications
Maximum operating pressure ...................................................................... 25 MPa (3600 PSI)
Material inlet thread size ............................................................................... NPSM 1/4"
Diffuser thread size ....................................................................................... 7/8 - 14 UNF-2A (G)
Wetted parts material .................................................................................... High-grade steel,
Operating temperature range ....................................................................... 5ºC to 40ºC
Maximum material temperature ................................................................... 43ºC (109ºF)
Maximum sound output ................................................................................ 81 dB(A)*
Weight
120 cm ....................................................................................................... 1.8 kg (4 lb.)
200 cm ....................................................................................................... 3.2 kg (7 lb.)
*
Measurement location: 0.5 m away from the coating surface, 0.5 m behind the spray gun,
spray pressure 12 MPa, tip size 0.021
Pole Gun
GB
11/16 - 16 UN-2A (F)
aluminum, Teflon,
hard metal
(40ºF to 104ºF)
13
Tabla de contenido
