Sammic GAE 300 Manual De Instrucciones página 9

PROBLEM
The motor does not start when the green
button is pressed.
During operation, the blade slows down or
stops.
The motor starts, the machine starts making
noise, the motor overheats or there is an
unpleasant smell.
The product does not slice easily.
The slices have uneven edges.
Blade does not sharpen properly.
Meat holder plate or additional sliding plate
does not move smoothly.
Problems disconnecting the meat holder plate at
the end of the range on the operator's side with
the thickness regulator plate adjustment handle
in the zero position (or disconnection outside
this position).
The meat press arm does not lock.
POSSIBLE CAUSE
No power supply in appliance.
No mains power supply.
Faulty electrical circuit.
Unsuitable products are being sliced (frozen
or containing bones).
Appliance designed for three-phase 400 V
power supply but connected to three-phase
230 V supply.
Wear of drive system or motor.
Blunt blade.
Blunt blade.
Worn blade.
Dirt in tooth.
Worn tooth.
Blade wear exceeds legal limit (-10 mm of
original diameter).
Guide rails not lubricated properly.
Self-lubricating wheels, bearings and
bushings broken.
Wear of cinematic system components.
Wear of cinematic system components.
SOLUTION
Check that the appliance is properly plugged in.
Check whether power is supplied to the
mains socket.
Contact the authorised support service.
Defrost or debone the product before you cut it.
Unplug the appliance and contact the
authorised support service.
Unplug the appliance and contact the
authorised support service.
Sharpen the blade.
Sharpen the blade.
Contact the authorised support service to
replace the blade.
Clean the tooth.
Contact the authorised support service to
replace the tooth.
Contact the authorised support service to
replace the blade.
Lubricate guide rails.
Contact the authorised support service to
replace them.
Contact the authorised support service.
Contact the authorised support service.
EN 9