Waring Commercial MX Serie Instrucciones De Uso página 10

NOTE: If you are installing a sound enclosure as an optional accessory,
remove the standard jar pad to access the screw holes on the upper
housing. This jar pad will not fit properly with the sound enclosure. To remove
it, peel it back, starting in the corner and working your way over the drive
coupling until it is completely off the base unit, as seen in Figures 1, 2 and 3.
Figure 1
Figure 6
Figure 11
Once you have finished removing the standard jar pad OR if your blender
came packed with a sound enclosure, follow these instructions:
Step 1: Find the 3 screw holes located on the left, back and right sides of
the upper housing as seen in Figures 4, 5 and 6.
Step 2: Place the base of the sound enclosure on the motor housing so the
screw holes on the enclosure line up with the screw holes on the
base. Use a Phillips-head screwdriver and the 3 screws included
with sound enclosure to secure the enclosure to the base unit in the
3 locations as seen in Figures 7, 8 and 9.
Step 3: Once the sound enclosure is secured tightly, select the custom jar
pad (included with sound enclosure). Please note the standard jar
pad will NOT fit properly with the sound enclosure. The correct
custom jar pad has a recessed area around the outer edge. It also
has a curved front with tabs on the sides, as seen in Figures 10, 11,
and 12. This curved area should face the front of the blender.
Step 4: Attach custom jar pad included with sound enclosure onto upper
housing with the curve facing out, as seen in Figure 13. Press tightly
around coupling to secure custom jar pad onto upper housing, as
seen in Figures 14 and 15.
INSTALLING THE SOUND ENCLOSURE
Figure 2
Figure 7
Figure 12
Figure 3
Figure 8
Figure 13
10
Figure 4
Figure 9
Figure 14
Figure 5
Figure 10
Figure 15