Switching Between Video Sources; Playing Two Video Sources At Once; Disabling Automatic Power On; Returning Adjustments To The Factory Settings (Reset) - Clarion VM700B Manual De Instrucciones

Switching between Video Sources

If your vehicle has two video sources, for example, a DVD player goes to Video1 and a
game console goes to Video, you can easily switch between them.
1. Press the SOURCE key.
The monitor will display Video1. Press the SOURCE key to select the input for
Video for the game console.
. Press the SOURCE key again to select Video1 input for DVD player.
Note :
• If you're using only one video source, the screen remains dark when you select
the unavailable source.
• Default unit setting is Video1 for normal case.

Playing Two Video Sources at Once

If your vehicle is equipped with two LCD monitors in the headrests and two video
source units, two different video sources can be viewed at the same time.
Each monitor transmits the infrared audio signal over its own channel, A or B. When a
vehicle has two monitors, the default is to configure the monitor in the driver's headrest
to use IR channel A, and the monitor in the passenger's headrest to use IR channel B.
You can change this.
1. Press the MENU key several times to locate the IR TRANSMITTER option.
. Press down " " or up "
Note :
• You don't need to select the IR channel if your vehicle has only one monitor.

Disabling Automatic Power ON

Your monitor is preset at the factory to switch on when you turn on your vehicle's ignition.
However, you can set it up to remain off until you press POWER on the monitor.
1. Press the MENU key several times until you reach the SCREEN OFF option.
. Press down " " or up "

Returning Adjustments to the Factory Settings (Reset)

1. Press the MENU key several times to locate the RESET option.
. Press either down "
If you don't wish to reset the settings, either press MENU again or wait for the monitor
to exit the picture adjustment menus automatically.
Note :
• If you reset the options and the monitor was set to source 2 (Video2), the monitor
reverts to the default setting of Video1. If there is no active video source on Video1,
the screen may go dark. Press SOURCE to switch the monitor back to Video2.
• The reset settings only valid for the Tint, Color, Brightness, Contrast, Volume that
setting those parameter back to default value 14, and set to IR CHA, AUTOPOWER
ON.
VM700B Manual 08509 R.indd 11
" to alternate between A and B or OFF.
" to turn automatic power ON or OFF.
" or up " " to reset the settings.
11
VM700B
8/8/009 9:58:7 AM