Nice OXILR Instrucciones Y Advertencias Para La Instalación Y El Uso página 8

... Observe when LED "B" emits signals
The system can be programmed in Mode 1 or in Mode 2: see Paragraphs 3.1 and 3.2.
3.1 - Memorisation in "Mode 1"
While Procedure 1 is being carried out, the receiver memorises all the command keys present on the transmit-
ter, automatically assigning output 1 of the receiver to the 1
procedure terminates, the memorisation will occupy a single memory location and the command associated
with each key will depend on the "List of commands" present on the automation's control unit.
PROCEDURE 1 - Mode 1 memorisation
01. On the receiver: hold down key A and wait for the green LED
B to light up. Subsequently, release key A.
02. On the transmitter being memorised:
(within 10 seconds) on the transmitter: press and immediately
release any command key; LED B (on the receiver) will flash
green 3 times (=memorisation completed correctly). (*1)
(*1) Note - If there are other transmitters to be memorised, repeat step 02 within the next 10 seconds.
The procedure will terminate automatically once this time elapses.
3.2 - Memorisation in "Mode 2"
While Procedure 2 is being carried out, the receiver memorises a single key among those present on the trans-
7 - English
key, output 2 to the 2
st nd
key, and so forth. Once the