Infra-Red Communications Head Wfz.irda-Usb; Parameter Settings - Honeywell EW701 Instrucciones De Operación E Instalación

Infra-red communications head WFZ.IRDA-USB

When communicating via the infra-red communications head WFZ.
IRDA-USB with an EWA600C-RF..., an unintentional communication
attempt with the heat meter is possible.
This generates a temporary hardware error in the heat meter and this is indi-
cated in the HMA suite.
This error is reset in the heat meter after approx. 1 minute.
To avoid this we recommend covering the IrDA interface of the heat meter
during communication via the infra-red communication head WFZ.IRDA-USB.
Change between S-mode and C-mode
To change the modes, you need the HMA suite, a PC and the infra-red com-
munication head WFZ.IRDA-USB.
Device information read out
• Current consumption value
• Due date value
• Due date
Radio parameters
Radio frequency
Transmission power

Parameter settings

The HMA suite parameter setting software, a PC and the respective infra-red
communication head (WFZ.IRDA-USB) can be used to set parameters for the
radio add-on modules and transmit installation telegrams.
AMR & walk-by
"Customer location" as freely selectable fi eld (max. 8 digits)
Walk-by
• Start of transmission
• Type of readout
V1.00 / 3.5.2018
• 13 monthly values
• Error code
• Error date
S-mode (868.30 +/- 0.30) MHz
C-mode (868.95 +/- 0.25) MHz
max. 10 dBm (C-mode)
• Transmission delay
• Transmission-free days
MU2H-0501ge23 R0318 49 EN