Engine Oil Maintenance; Checking Engine Oil; Adding Engine Oil - Westinghouse iGen2300 Guía De Rápida Instalación

MAINTENANCE

ENGINE OIL MAINTENANCE

Engine Oil Specification
1. Only use the engine oil specified in Figure 12.
2. Only use 4-stroke/cycle engine oil. NEVER USE
2-STROKE/CYCLE OIL. Synthetic oil is an acceptable
substitute for conventional oil.
Figure 12: Recommended Oil

CHECKING ENGINE OIL

NOTICE
Always maintain proper engine oil level. Failure to
maintain proper engine oil level could result in severe
damage to the engine and/or shorten the life of the
engine.
Always use the specified engine oil. Failure to use the
specified engine oil can cause accelerated wear and/
or shorten the life of the engine.
Engine oil level should be checked before every use.
1. Always operate or maintain the inverter on a flat
surface.
2. Stop engine if running.
3. Let engine sit and cool for several minutes (allow
crankcase pressure to equalize).
4. Remove the engine service panel to access the oil fill/
drain plug.
5. With a damp rag, clean around the oil fill/drain plug.
6. Remove the oil fill/drain plug.
7. Check oil level: When checking the engine oil, remove
the oil fill/ drain plug.
• The oil level is acceptable if oil is visible at the
bottom of the threads of the oil fill plug.
• If oil level is low, add to the correct level using
the supplied oil fill bottle. Do not overfill the oil
crankcase.
NOTICE
Engine oil must always be checked and added when
the inverter is on a flat, level surface, or an inaccurate
reading may result, causing serious engine damage.

ADDING ENGINE OIL

1. Always operate or maintain the inverter on a flat
surface.
2. Stop engine if running.
3. Let engine sit and cool for several minutes (allow
crankcase pressure to equalize).
4. Remove the engine service panel to gain access to
the oil fill/drain plug.
5. Thoroughly clean around the oil fill/drain plug.
6. Remove the oil fill/drain plug.
7. Select the proper engine oil as specified in
Figure 12.
8. Using the supplied oil funnel, slowly add engine oil to
the engine. Stop frequently to check the oil level and
avoid overfilling.
9. Continue to add oil until the oil is at the
correct level.
Westinghouse Outdoor Power Equipment | 19
If oil level is below
this line it is too
low to operate.