Smarter tools CUT-40 Manual Del Usuario página 7

•
Do not drape cables over your body.
•
If earth grounding of the work-piece is required, ground it directly with a
separate cable.
•
Do not touch torch if you are in contact with the work, ground, or another
torch from a different machine.
•
Use only well-maintained equipment. Repair or replace damaged parts at
once. Maintain unit according to manual.
•
Wear a safety harness if working above floor level.
•
Keep all panels and covers securely in place.
•
Clamp work cable with good metal-to-metal contact to work-piece or
worktable as near the weld as practical.
•
Insulate work clamp when not connected to work-piece to prevent contact
with any metal object.
•
Do not connect more than one torch or work cable to any single output
terminal.
SIGNIFICANT DC VOLTAGE exists after removal of input power.
•
Turn Off inverter, disconnect input power, and discharge input capacitors
according to instructions in Maintenance Section before touching any parts.
FUMES AND GASES can be hazardous.
•
Keep your head out of the fumes. Do not breathe the fumes.
•
If inside, ventilate the area and/or use exhaust at the arc to remove welding
fumes and gases.
•
If ventilation is poor, use an approved air-supplied respirator.
Fumes emitted from the plasma cutting process displace clean
air and can result in injury or death. Breathing these fumes and
gases can be hazardous to your health.
1-3