Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10
MAINTENANCE & LUBRICATION CHARTS
10.1 GENERAL________________________________________________________________
10
MAINTENANCE & LUBRICATION CHARTS
The mower was designed for minimum lubrication. Over
greasing will produce high loads on the bearings and
engine, thereby reducing the performance of the
machine.
NOTICE
All maintenance intervals must be performed more
frequently
when
operating
conditions.
WARNING
!
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
engage parking brake, stop engine, and disconnect
spark plug wire to prevent injuries.
1.
Always clean grease fittings before and after lubrication.
10.2 MAINTENANCE CHART ____________________________________________________
Air Cleaner
Combustion Chamber
Engine Oil
Fuel Line
Fuel Strainer
Spark Plug
Valve Clearance
Grease Locations
L
- L
1
4
L
- L
5
6
L
7
L
- L
8
9
L
10
L
11
A - Add or Adjust
* Indicates initial service for new machines.
Engine Oil - See Section 8.3
I
Manual grease gun with NLGI Grade 2 (Service Class LB).
II
Lubriplate
marine grease, Jacobsen Part No. 5001581
®
III
34
in
extremely
dusty
Recommended Service and Lubrication Intervals
Every
Every
8-10
20
Hours
Hours
I
I
R*
L
C - Clean
I - Inspect
2. Lubricate with grease that meets or exceeds NLGI
Grade 2 LB specifications. Apply grease with a
manual grease gun, and fill slowly until grease
begins to seep out. Do not use compressed air.
3. For smooth operation of pivot points and other
friction points, apply several drops of SAE 30 oil
every 50 hours or as required.
4. To lubricate points (L
wheel.
Remove nut (A) from end of shaft and pull wheel hub
(D) off. Remove collar (B) and bushing (C) then pack
bearing (L
) with lithium grease.
7
Remove mounting bracket (E) to gain access to
fitting (L
). Turn the traction drum if pulley (F) is
6
blocking the fitting then insert grease gun through
hole and carefully apply grease.
5. To lubricate point (L
one pump of grease to fitting on end of shaft.
Every
Every
Every
50
100
250
Hours
Hours
Hours
C
C
R
C
A/R
A
L
L
L- Lubricate
R - Replace
and L
), remove left transport
6
7
), remove cover (G) and apply
10
Yearly
Lubricant
Type
I
R - 2yrs
L
II
L
II
L
III
L
III
II
L
II
AR - As Required
Capítulos
Tabla de contenido
