Ferroli CALLISTO Manual De Instalación, Uso Y Mantenimiento página 39

4.2 Use via remote control
The remote control is a device that transmits via radio waves, therefore it does not have to be pointed at the
receiver unit in the control panel.
In an open space, the remote control operating range is over 10 meters. In the presence of walls or other obstacles,
the range can be reduced by a few meters.
Before using the remote control it is necessary to carry out tuning with the electronic board of the insert. This may
be necessary at first activation or when the data communication channel between the board and remote control is
interrupted. In this case, the display will show the message SEARCHING FIELD. The tuning operation may also be
required when there are other appliances which create interference with the insert.
To carry out this operation, proceed as follows:

Disconnect the stove power supply.

Press buttons P3 and P5 at the same time. The message RADIO ID 0#. will appear. With the scroll buttons
select NEW UNIT' and confirm with buttons P5.
Select the ID value with the P1 and P2 buttons from 0 to 64 (default ID = 0).

Connect the stove power supply.

Within 10 seconds after turning on the power, confirm the selected channel by pressing button P5.
The message UNIT LOADED and then stove status will appear in quick succession while the emergency
LEDs remain stationary for a short time in confirmation of acquisition.
If the message SEARCHING FIELD appears, tuning was unsuccessful and the procedure must be
repeated.
The remote controller display changes according to the status of the insert, or the menu displayed. When idle, the
display shows the following items:
LCD Display
Time
During the normal operation, the data transmission happens to regular intervals of time.
To turn on the radiocomando to press the key P3 with the visualization of the state of the insert with some second of
delay.
To press the key P4 to access the menu, P5 to activate the function, P1 and P2 for the choice of the parameter.
Following the available functions are listed:
- BACK ILLUMINATION (adjustable duration from 2 to 10 sec)
- POWER ON (Time ON of the radicomando)
- BRIGHTNESS' (ON. OFF)
- CONTRASTt (Regulation contrast)
- BUZZER (I Play to the pressure of the keys of the radiocomando)
4.2.1 Lighting
Before lighting the stove:

make sure to have read and understood the instructions in the manual;

the hopper must be filled with pellets;

the combustion chamber must be clean;

the brazier must be completely free, clean of any combustion residuals and properly positioned in the
brazier holder;

check the hermetic closure of the fire door and ash pan;

make sure the stove is completely inserted in its compartment and that it is properly electrically powered.
- At first lighting, remove any components that could burn (instructions/label) from the insert firebox.
- Any lightings done after long unit idle periods require the renewal of any pellets that have been inside the hopper
for a long time (in being a damp fuel no longer suitable for combustion) and complete cleaning of the combustion
chamber.
- Do not use flammable liquids to light the unit.
- In case of persistent failed lighting, contact the Service Center.
39
Room temperature
Insert function
Insert function
CALLISTO