12. CONNECT THE WIRING
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power from being switched on accidentally.
Remove wiring cover from rough-in plate and set aside.
Connect wires as follow: BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw. DO NOT FORGET
TO CONNECT THE GROUND. Reinstall wiring cover.
13. FINISH THE DRYWALL BOX
Finish the drywall box. Check fitting with dry wall trim before mounting it to the hood.
14. MOUNT THE DECORATIVE FLUE COVER OR THE DRYWALL TRIM ON THE HOOD
The decorative flue cover AEIP Series and the drywall trim ATDIP Series may have sharp edges. Be careful when
handling and installing these metal parts.
14.1 I
D
NSTALLATION WITH
Remove the protective plastic film covering the decorative flue
cover AEIP Series. Assemble the flue cover on top of hood using
(14) no. 8 x 3/8" screws (provided with decorative flue cover). See
illustration at right to locate mounting screws from top of hood.
NOTE: Ensure edges fit perfectly before tightening completely the
mounting screws.
14.2 I
D
NSTALLATION WITH
Remove the protective plastic film covering the drywall trim ATDPI
Series. Assemble the drywall trim on the top of the hood using
(14) no. 8 x 3/8" screws (provided with drywall trim). See illustration
at right to locate mounting screws from top of hood.
NOTE: Ensure edges fit perfectly before tightening completely the
mounting screws.
15. INSTALL THE HOOD
15.1 I
D
NSTALLATION WITH
Assemble the hood assembly to the mounting brackets by aligning keyholes with
4 nuts previously installed in step 8 (2 nuts per side). While holding the hood, remove
one nut and install a washer (included in parts bag) on each pem stud, then reinstall
the nut and tighten it. See illustration at right.
15.2 I
D
NSTALLATION WITH
Align hood keyholes with pem studs on brackets. Secure the hood to the brackets
using washers and nuts (included in parts bag). See illustration at right.
(INSTALLATION WITH DRYWALL TRIM ATDIP SERIES ONLY)
F
C
ECORATIVE
LUE
OVER
T
ATDIP S
RYWALL
RIM
ERIES
F
C
ECORATIVE
LUE
OVER
T
ATDIP S
RYWALL
RIM
ERIES
WARNING
!
WARNING
!
AEIP S
ERIES
HD0233
AEIP S
ERIES
10
M
OUNTING SCREWS LOCATION
HD0234