Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. PREPARE THE BLOWER HOUSING
Detach the blower housing from the hood by removing both retaining screws (A).
Keep the screws for further use.
Fold up both flanges (B). The flanges must be perpendicular to the top of the
blower housing.
5. REMOVE THE FILTERS AND THE GREASE DRIP RAIL
A. Remove tape on filters. Remove filters from hood and
set aside.
NOTE: It is recommended to start with the center one.
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.
6. REMOVE THE PAN
NOTE: Do not remove the 4 screws located on the
notched parts of the pan (A on figure below).
HD0223
A
Using a Phillips no. 2, remove 8 screws
retaining the pan (shaded part on
illustration at right) to the hood.
Remove the pan and set aside.
A
HD0229
HD0222
7
B
1
R
ETAINING SCREWS LOCATION
HD0224
HD0238
A
B
Tabla de contenido
