Dea REV Instrucciones De Uso página 29

5 How to adjust the limit switche
1. Scroll down the parameters untill you visualize
P001;
2. confi rm by pressing the
3. by pressing (OPEN) and
leaf in the opening position and adjust the limit
switch cam so that it pushes the microswitch in that
point;
Repeat adjusting the closing limit switch.
4. Confi rm by pressing the key (display shows again
P001).
6 Motor stroke learning
1. Make sure you have properly adjusted the opening/closing limit switches cams;
2. Scroll down the parameters with
3. Access the parameter by pressing the
4. When " " fl ashes, continue pressing the
5. Release the key when "
6. Wait for the door searches and stops on the opening stop and then on the closing stop.
7. Once the procedure is ended, the display will show "- - - - ".
7 Transmitters learning
7.1 Transmitters coding selection
1. Scroll down the parameters with
P027;
2. Confi rm by pressing on the
3. Select the type of transmitter by scrolling
- d000=fi x rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confi rm by pressing on the
Warning: If you need to vary the type of encoding, and only if other remo-
tes with different encoding are memorized, you need to erase memory
(P004) AFTER you have set the new encoding.
key;
(CLOSE), move the
and keys until you visualise P003;
key;
key;
" stops fl ashing; Start the learning procedure with operator 1 opening;
and keys until you visualise
key;
and keys:
key (display shows again P027).
27