Adjustable Cutting Rule; Changing Position From 300 To 350Mm Blade - Sima VENUS-85 Manual De Instrucciones Original

A breakthrough may lead to excessive speed of cutting or
blocking the blade.
The coolant pump is started simultaneously with the motor. Before
approaching the material to the blade, make sure it gets enough
water.

9.4 ADJUSTABLE CUTTING RULE

Let´s place the adjustable angle ruler(A) which is supplied
with the machine on the front of the sliding cart (B) let it slip as
wished. Then fix the ruler to the sliding cart with the nut. Afterwards
loose the knob and turn the adjustable ruler up to 0 positions and fix it
again.
The piece to be cut is placed resting on the top front of the
machine (B,) the adjustable rule may be placed on either side of the
piece as needed, and the court will run manually pushing the machine
to drive.

9.5 CHANGING POSITION FROM 300 TO 350MM BLADE

To use blades of diameter 300 and 350 will have to adjust the cutting unit at different heights. Proceed as
follows
Warning: Never use a 350mm blade when you are in 300 position as you will cut the sliding cart.
1. Loosen the handle, and lower the cutting unit with care.
2. Tighten the knob to set the cutting unit.
3. Protection is disproportionately tilted.
4. Loosen the screws from safeguard blade with a 19mm wrench.
5. Place safeguard in a horizontal position.
6. Tighten the screws of the safeguard blade.