Electrical Equipment - Sima VENUS-85 Manual De Instrucciones Original

5. ELECTRICAL EQUIPMENT

The electrical equipment of the SPADA MKNO cutting tables manufactured by SIMA, S.A. has an IP54 protection
degree.
The power supply on this machine has a low minimal tension coil to avoid any unexpected starting-up of the
machine. When there is a power cut or a fall of tension that causes the machine to stop, and once the normal power
conditions have been re-established, the motor does not start until the green button is pressed.
ATENCIÓN: The three-phase SPADA MKNO models leave the factory prepared to work at 400V.
ATENCIÓN: When necessary to use a three-phase power tension at 230V, we need to swap the positions of
the bridge plates in the motor terminals box, as indicated in the following figure:
ATENCIÓN: The extension cable used to feed the machine needs to have a minimum section on the table as
shown below