Djustable Cutting Rule; Changing Position From 300 To 350Mm Or 350 To 400Mm Blade - Sima DAKAR Manual De Instrucciones

9.4 DJUSTABLE CUTTING RULE

Let´s place the adjustable angle ruler(A, Fig.6) which is supplied with the machine on the front of the sliding
cart (B, Fig.6) let it slip as wished. Then fix the ruler to the sliding cart with the nut. (C, Fig.6). Afterwards loose the
knob (D, Fig.6) and turn the adjustable ruler (E, Fig.6) up to 0 positions and fix it again.
The piece to be cut is placed resting on the top front of the machine (B, Fig.6) the rule (A, Fig.6) may be
placed on either side of the piece as needed, and the court will run manually pushing the machine to drive.
Start slowly and progress according to grade the depth of cut and material hardness. An excessive advance
may lead to a faulty cutting or blocking the disk.
The coolant pump is started simultaneously with the engine. Before approaching the material to make sure it
receives the necessary water.

9.5 CHANGING POSITION FROM 300 TO 350MM OR 350 TO 400MM BLADE

To use blades of diameter 300 and 350 or 350 and 400 will have to adjust the cutting unit at different
heights. Proceed as follows:
• Change the top of the column position. Steps 1 and 2.
• Loosen the eight screws that secure the column. Step 3.
• Raise or lower the column as needed. Pass 4
• Tighten the eight screws. Step 5.
• Mount the new disk and its guard. Step 6.
14
ENGLISH
Warning: Never use a 400mm
blade when you are in 350
position as you will cut the
sliding cart
Warning: Never use a 350mm
blade when you are in 300
position as you will cut the
sliding cart.