Filling The Tray With Water; Position Of The Machine And The Operator, Connection And Disconnection - Sima VENUS-85 Manual De Instrucciones Original

9.2 FILLING THE TRAY WITH WATER

SPADA MKNO cutters are designed to work with water-cooled diamond chains, so that a significant part of its structure
is a tray designed to serve as a reservoir of cooling water which is pumped in closed circuit to the blade.
WARNING: Before connecting the machine to the network to begin
any cutting operation should proceed to fill the tray to the level
sufficient to cover the pump completely
During cutting operations accumulate lots of dirt on the tray so the water should be changed as often as necessary to
ensure the smooth operation of the pump and the perfect cooling of the blade, the tray features a drain plug that
facilitates this operation.
WARNING: Do not forget to wash the pump at the end of each day. To do this, unscrew the circular
battery, immerse the pump in a bucket of clean water, plug the machine and circulate the water until fork
clean water for cooling, disconnect the machine and screw back the cap to the pump.

9.3 POSITION OF THE MACHINE AND THE OPERATOR, CONNECTION AND DISCONNECTION

The machine needs to be installed in well illuminated, stable and plane surface, free from any obstacles.
Before starting-up the machine, we should have gone through all necessary safety measures (electrical
connection, stability, protections, etc....) as mentioned in the previous chapters.
When installing the machine, make sure the table on which it will be placed should be a horizontal, non bland
surface.
This machine is not to be used under rain and always work in good illumination conditions.
To start cutting, the operator should stand in from of the machine. In this position, the operator can easily
manage the cutting head and the piece to be cut. He/she will also have easy access to the electrical plug.
Once the power supply cable is connected, the motor and the water puma start-up only by pressing the green
switch button.
The machine can be stopped, simply by pressing the red switch button.
The cut is executed manually holding the material resting on the bed and pulling the cutting unit or spinning
the wheel of the transmission according to model purchased.
Start slowly and progress according to grade the depth of cut and material hardness.