Tabla de contenido
Idiomas disponibles
Idiomas disponibles
In position A, the automatic load detection is
activated: The stroke speed is reduced in
idling and is controlled to the highest value
when the blade enters the workpiece.
Recommended stroke speed (position
of the adjusting wheel)
Hard and soft wood, plywood board,
plywood, chip board
Hardboard
Plastic
Ceramic,
aluminium,
metals
Steel
8
Working with the machine
CAUTION
Material with high dust generation (e.g.
plasterboard)
Damage to machine through dust pene-
tration, risk of injury
X
Do not work overhead!
When working on small or thin workpieces,
always use a stable base, or the CMS module
(accessory).
When working, hold the electric power tool
by the handle and guide it along the desired
cutting line. For precise cuts and smooth
running, use two hands to guide the electric
power tool.
Freely guided sawing along a scribe
mark
The triangular shape of the splinterguard
1]
points to the cutting line of the saw blade.
This facilitates sawing along a scribe mark.
8.1
Lighting
WARNING
The stroboscope light may make it diffi-
cult to determine the saw blade posi-
tion
Risk of injury
X
Ensure the work area is well illuminated.
A continuous light or stroboscope is installed
for illuminating the cutting line:
up to approx. 2100 rpm: continuous light
A
4 - A
3 - A
non-ferrous
3 - 5
2 - 4
[4-
from approx. 2100 rpm: stroboscope light
L In overhead position (+/- 45°), the light-
ing is switched off completely.
9
Service and maintenance
WARNING
Risk of injury, electric shock
X
Always disconnect the mains plug from the
socket before performing maintenance
work on the machine!
X
All maintenance and repair work which re-
quires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indi-
cated in the operating manual.
To ensure constant air circulation, always
keep the cooling air openings in the motor
housing clean and free of blockages.
– Check the guidance roller regularly for
wear.
– Regularly remove dust deposits from the
chip guard.
– Regularly clean the base runner to prevent
scratches and cores on the surface.
10
Accessories
Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
10.1
Saw blades, other accessories
In order to saw different materials quickly
and cleanly, Festool offers saw blades for all
applications that are specially designed for
your Festool jigsaw.
CARVEX
GB
17
Capítulos
Tabla de contenido
