Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ICEMAKER INSTALLATION INSTRUCTIONS - T
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
WARNING
•
To eliminate the
risk of electric shock or injury during
installation, you must first unplug the
refrigerator before proceeding. Failure
to follow these instructions can result in
electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
R
E
M
O
V
E
T
H
E
O
U
1
Go to the back of the refrigerator, and peel off the
outlet cover.
INSTALL FILL TUBE
2
On the
fill tube assembly
backing. Remove the adhesive backing and slide
the tube into the hole near the middle at the back
of the refrigerator. Firmly press on the fill tube
assembly to secure it to the refrigerator by clipping
the bottom tab. Drive the
grommet.
Installation Instructions
Sharp knife
Pliers
L T
T E
C
O
V
E
R
Remove only to install
water fill tube.
(9) there is adhesive
(11) through the
screw
11
9
tab
PREPARE FOR INSTALLATION
3
Remove the top full-width basket on freezer
drawer:
A. Pull the basket out to the stop location.
B. Lift the basket up to release it from the slides.
When replacing the basket,
basket remains mounted on the side rails and over
the slides of the bottom basket.
Remove the outlet cover with a flat-blade
screwdriver.
8
make sure that the
Outlet
cover
Capítulos
Tabla de contenido
