Kongskilde RVS 5000H Instrucciones De Funcionamiento página 4

Never put your hand into the separa-
tors intake or outlet while the separator
is in operation.
Mounting:
The separator is lifted by the lifting eyes. Weight of the
separator; see section "Technical data".
It should be avoided that the separator outlet is clogged
or blocked with material as this may damage the sepa-
rator. If necessary, a level sensor can be installed under
the separator exit which interrupts the system upon
activation.
Operation in combination with cardboard, carton
and paper
Cover plates and corresponding bolts as well as nuts
on both sides of the rotor are removed (see illustration).
In addition, the supplied plugs must be placed in the
pipes, which are then secured with the bracket at-
tached by the two bolts. Finally, the air damper must be
removed to ensure that material does not accumulate
around the bearings, see the following section.
Operation in combination with plastic and metal foil
Cover plates and corresponding bolts as well as nuts
on both sides of the rotor are mounted (see illustra-
tion). Furthermore, the accompanying brackets and the
two plugs must be removed. Hereby, the vacuum in
the material inlet will suck an airflow around the bear-
ings of the rotor, through the holes below the bearings.
Thereby the bearings are kept free from foil that could
eventually damage the bearings. Finally, the air damp-
ers on both bearings should be adjusted, see the sec-
tion below.
4
Location of lifting eyes for the separa-
tor.
RVS 2000 - 60000
Illustrationer for RVS brugsanvisni
Revision:
121102942