Upper Control Handle Cable Replacement - Stryker 6253 Manual De Uso

UPPER CONTROL HANDLE CABLE REPLACEMENT

Tools Required:
• 5/8" Wrench
Procedure:
1. Pull the cable and raise the extendable upper control
handle to the fully extended position.
2. Using a 5/8" wrench, remove one side of the cable.
3. Place the washer on the end of the new cable.
4. Using a 5/8" wrench, attach one side of the new cable
to the chair frame in the hole where the old cable was
removed.
5. Repeat steps 2-4 for the other end of the cable.
Figure 51 - Place the washer on the new cable
www.stryker.com
Service Information
6253-001-166 REV C
Figure 49 - Raise the extendable handle
Figure 50 - Remove one side of the cable
Figure 52 - Attach one side of the new cable
Return To Table of Contents
English
1-37