Operation; Operating Position - Maruyama B230C Manual Del Propietário

WARNING
POTENTIAL HAZARD
• The components of your recoilstarter
assembly are under high spring tension.
If improperly disassembled these parts
maystrike you with considerable force,
possibly causing personal injury.
WHAT CAN HAPPEN
• Contact with the parts can cause severe
personal injury.
HOW TO AVOID THE HAZARD
• Never attempt to disassemble your recoil
starter assembly yourself. Always consult
your authorized MARUYAMA dealer for
repair by qualified service technicians.
CAUTION
• Do not pull the Starter rope all the way out.
Hot Restart
To start an engine that is already warmed up (hot restart),
or if the ambient temperature exceeds 68°F (20°C):
1. Pump the primer bulb at the bottom of the
carburetor until fuel can be seen flowing through
the fuel return line to the fuel tank.
(Flowing fuel should be almost clear, not foamy
or full of bubbles.)
2. Move the choke lever to the open (
move the stop switch to the "START" (ON) position.
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (US-14).
If the engine fails to start after you follow the
above procedu res, contact an author ized
MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle trigger.
2. Slide the stop switch to the "STOP" (OFF)
position.
STOP (OFF)
Fast-idle lock
) position and
START (ON)
Stop Switch
In fast-idle start
position
In idle position
— US-15 —

Operation

WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by
Trimmer.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Trimmer without the
debris shield in place.
CAUTION
• Read the Safety instructions on US-7
concerning proper use of the Trimmer.

Operating Position

Hearing Protection
Right Arm
Slightly Bent
Hand Holding Throttle Grip,
Fingers on Throttle Trigger
CAUTION
• Always wear gloves and protective cloth-
ing when operating the String Trimmer.
Before using the Trimmer, check the following:
1. Make sure the 3 mm hex wrench has been
removed from the bearing case and boss adapter
before you star the engine.
2. The Trimmer should be on the operator's right side.
3. The operator's right hand should be holding the
shaft grip, with his or her fingers on the throttle
trigger. The right arm should be slightly bent.
Eye Protection
Left Arm Fully Extended,
Hand Holding Loop Handle
Trimmer Head Near
and Parallel to Ground