Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ATTENTION!
The figures mentioned in the chapters are shown on the initial pages of this manual.
UNIT DESCRIPTION
Sturdy steel structure with 1/1 GN tray, 150 mm high,
kept at the correct temperature, thanks to a lower heating
element and an infra-red ceramic heater placed on the
tank. The stainless steel feet of the cabinet version can be
adjusted in height.
Legal and technical requisites
The manufacturer declares that the appliances are made
in conformity with the EEC directives and requires that
the installation is performed in accordance with the
regulations in force.
During the assembly, the following requisites should be
adhered to:
- building regulations and local fire prevention provisions
- health and safety regulations
- current CEI regulations
- current Fire Brigade regulations
INSTALLATION
Handling and transportation
The units are placed on wooden pallets to facilitate
transportation and handling by a forklift or trolley either
on the premises or when they are loaded and unloaded.
Units are packed in 3-layer sturdy cardboard boxes with
stickers and prints applied onto them for providing advice
relevant to handling. The symbols give information about
their handling, forbid the lifting the units with hooks and
storing outdoors.
It also warns operators that the packaging contains fragile
objects and indicates the vertical position that the box
must keep. It also directs the operator on opening the
packaging from downwards to upwards.
Before beginning the installation, remove the packaging.
A few parts are protected with an adhesive film, which
should be removed carefully. Remove any glue residual
with the proper substances never use abrasive substances.
The unit must be levelled; small differences of height can
be solved by adjusting the feet. In the Top versions, make
sure that the bench or the cabinet you have chosen can
bear the unit. The main switch or the socket must be close
to the unit and easy to reach. We recommend placing
the unit under a suction hood so that vapour can quickly
evacuate.
WARNING:
If the following models:
INSTALLATION INSTRUCTIONS
MOD.
V
kW:
N°:
Hz: 50/60
IPX4
E7SP4M - SE7SP-4M- SE9SP-4M are installed as a single
unit (not in a row), fix the anti-tilt bracket to the floor by
using the proper anchor screws (see Fig. 7); consider the
minimum installation distances described above. The free-
standing appliances that weigh less than 40 kg, must be
fixed to the surface where they rest by using the supplied
fixing kit (see Fig. 8).
Unscrew one of the legs and insert the pin in the largest
hole of the bracket "A", screw in the leg again with a
"B" screw. Always consider the minimum distance of
installation.
Room ventilation
The room where the appliance is installed must be fitted
with air intakes to guarantee the correct operation of the
unit and air exchange. The air intakes must be of adequate
dimensions, be protected by grids and positioned free of
any obstruction. (See Fig. 2 – Fig. 3).
Caution - Warning
Do not install the appliance near any other units
that can reach high temperatures: the electrical
components might be damaged. During installation,
make sure that the air suctions and the evacuation
ways are free of any obstacles.
INSTALLATION
The appliance must be put in operation and serviced by a
qualified person.
All the installation works must be carried out according
to the regulations in force. The manufacturer declines any
responsibility in the event of a wrongful operation due to
an improper or non compliant installation.
Install the unit keeping a distance of at least 15 cm from
the back wall and 15 cm from the side wall (see fig.1 – fig.
2).
In any case the unit must be installed/fixed in order it
is possible to replace the power supply cable after the
unit is installed. The walls near the appliance (walls,
decorations, kitchen cabinets, decorative finishes, etc.)
must be made of non-flammable material.
Warning!
Disconnect the general power supply before any
intervention.
| 33
EN
Tabla de contenido
