DeWalt DW450S2 Manual De Instrucciones página 11

FIG. 6
G
FPO
Directional Exhaust Defl ector (Fig. 7)
Disconnect air supply. Rotate exhaust deflector (B) to desired position.
Reconnect air supply.
Cold Weather Operation
WARNING: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection
when operating this tool. Keep the stapler pointed away from yourself
and others. For safe operation, complete the following procedures
and checks before each use of the stapler.
When operating tools at temperatures below freezing, complete
preparation procedures outlined above and follow the directions
below.
1. Make sure compressor tanks have been properly drained prior to
use. Always drain the compressor tanks at least once daily while
using the stapler. This is especially important in cold weather
because any moisture in the air in the tanks will condense in the
cold temperature.
2. Keep the tool as warm as possible prior to use.
FIG. 7
B
Hot Weather Operation
Tool should operate normally. However, keep tool out of direct sunlight
as excessive heat can damage bumpers, o-rings and other rubber
parts.
MAINTENANCE
from magazine before making adjustments or personal injury may
result.
Clear a Jam (Fig. 8–11)
jammed fastener.
The magazine is spring loaded to reduce jamming. When a jam does
occur, a quick release mechanism at the rear of the magazine allows
the magazine to move back, in order to clear the jam.
If a jam does occur:
9
3. Put 5 to 10 drops of D WALT Pneumatic Tool Oil or winter weight
E
pneumatic oil containing ethylene glycol in the end cap.
4. Lower air pressure to 80 psi or less.
5. Actuate the tool 5 or 6 times into scrap lumber to lubricate o-rings.
6. Turn pressure up to operating level (not to exceed 120 psi) and
use tool as normal.
7. Re-lubricate with D WALT Pneumatic Tool Oil or winter weight
E
pneumatic oil containing ethylene glycol in the end cap at least
twice a day or after 4 hours of use.
WARNING: Disconnect air line from tool and remove fasteners
WARNING: Always disconnect air supply before clearing a