Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Removing the screw strip
When removing the screw strip at or before using up the
screws, pull it out in the direction of the arrow.
008140
If you depress the reverse button, you can pull out the
screw strip in the reverse direction of the arrow.
1
008141
Extension handle (optional accessory)
008142
Use of extension handle allows you to drive screws into
floors while standing.
OPERATION
Driving operation
008143
1. Reverse button
1. Extension
handle
1
Switch on the tool by pressing the switch trigger and at
the same time pushing the lock button. Hold the tool
squarely against the workpiece and apply forward
pressure to the tool. The screw will be automatically
carried to the driving position and driven into the
workpiece.
NOTE:
Do not fire the tool without screws. This will
•
damage the workpiece.
Do not apply oil or grease on the sliding surface of
•
the feeder box.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
008144
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
6
1. Limit mark
1
1. Brush holder
cap
1
2. Screwdriver
2
Tabla de contenido
