Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Adjusting the driving depth
5mm
(3/16")
1
2
3
008279
Depress the stopper base as far as it will go. While
keeping it in this position, turn the adjusting knob until
the bit tip projects approx. 5 mm (3/16") from the stopper
base. Drive a trial screw. If the screw head projects
above the surface of the workpiece, turn the adjusting
knob in the A direction; if the screw head is counter-sunk,
turn the adjusting knob in the B direction.
Installing screw strip
1.
Squeeze the lock lever with fingers and open the
magazine cap.
1
2
008134
2.
Roll up the screw strip in a form of coil
counterclockwise
magazine.
1
2
008135
3.
Run the end of the screw strip on the slotted
passage starting from above the magazine.
1. Stopper base
2. Casing
3. Adjusting knob
A
B
1. Lock lever
2. Magazine cap
and
place
it
inside
1. Screw strip
2. Magazine
1
008136
4.
Close the magazine cap while squeezing the lock
lever with fingers.
1
008137
5.
Insert the top end of the screw strip into the
portion A of the feeder box and feed it in the
direction of the arrow.
1
the
008138
6.
Set the screw strip so that the first screw of the
strip seats with a space for one screw left before
the screw-driving position.
1
008139
5
1. Slotted passage
1. Lock lever
2. Magazine cap
2
1. Portion A
1. Screw-driving
position
Tabla de contenido
