Makita 6845 Manual De Instrucciones página 4

the switch trigger to stop.
Reversing switch action
1
A
008105
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
Hook
1
008108
The hook is convenient for hooking the tool to your belt.
It can be installed on either side of the tool.
Changing the installation position of hook allows
two-way setting of 10 mm (3/8") and 20 mm (13/16")
distance from the tool itself.
The tool with hook can be hung on the waist belt, a
maximum diameter 20 mm (13/16") pipe etc.
To remove the hook, just remove the clamping scew.
Place it on the tool and secure it with the clamping screw
to install.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
1. Reversing
switch lever
B
1. Hook
2. Clamping screw
2
Installing or removing the bit
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
1
2
008132
Press the dust cover toward the plane bearing and pull
out the bit. If the dust cover cannot be moved as far as
the plane bearing, try it again after turning the bit slightly.
To install the bit, insert it into the socket while turning it
slightly. After installing, always make sure that the bit is
securely held in place by trying to pull it out.
1
2
3
008133
Setting for desired screw length
1
002663
There are 3 positive-lock screw length settings. To
obtain the desired setting, pull out the stopper base
while depressing the lever until you see the number of
the desired screw length (indicated on the plate) appear
to rest on the very top edge of the casing. See the table
below for the relation between the number indicated on
the plate and the respective screw length ranges.
Number indicated on the plate
25/28
32
40
008278
4
1. Thumb screw
2. Casing
1. Plane bearing
2. Dust cover
3. Bit
1. Lever
2. Stopper base
3. Plate
2
4. Casing
3
4
Screw length range
25 mm(1") - 28 mm(1-1/4")
28 mm(1-1/4") - 35 mm(1-3/8")
35 mm(1-3/8") - 41 mm(1-9/16")