Description; Preparation Before Use - SDMO TECHNIC 20000TE AVR C Manual De Utilización Y Mantenimiento

1.3.12 Safety guidelines for handling batteries
Danger

2. Description

1 Earth connection
2 Oil dipstick
3 Oil filler plug
4 Oil drain screw
5 Fuel gauge
6 Fuel tank cap
7 Fuel tap
1 Dipstick
2 Maximum mark of dipstick
3 Minimum mark of dipstick
1 Fuel tap
1 Air filter cover nuts
2 Air filter cover
1 Spark plug cap
* Source inverter, battery charger, remote start-up control...

3. Preparation before use

3.1. Positioning the generating set for operation
Choose a site that is clean, well ventilated and sheltered from bad weather.
Place the generating set on a flat, horizontal surface which is firm enough to prevent the set sinking down (under no circumstances
should the set tilt in any direction by more than 10°).
Store the additional supplies of oil and fuel within close proximity, whilst maintaining a certain distance for safety.
3.2. Earthing the generating set
Danger
To connect the set to the ground: Attach a 10 mm
driven 1 meter into the ground.
Never leave the battery close to a flame or fire.
Use only insulated tools.
Never use sulphuric acid or acid water to top up the electrolyte level.
8 Air filter
9 MODYS
10 MODYS key
11 Circuit breakers
12 Power sockets
13 Starter battery
14 Exhaust silencer
4 Oil filter
5 Oil cooler cover fastening screws
6 Oil cooler cover
2 Clamps
3 Foam element
4 Paper element
2 Spark plugs
The generating sets supply electrical current when in operation: risk of electrocution.
Connect the generating set to the ground at each use.
2
copper wire to the set's earth connection and to a galvanised steel earthing rod
Figure A
Figure B
Figure C
Figure D
Figure E
15 Working hours counter
16 Pilot lamp
17 12V fuse for MODYS and lighting
230V fuse for MODYS and working
18
hours counter
19 Options connections *
20 Emergency stop button
21 Spark plugs
7 Oil cooler fastening screws
8 Oil cooler
3 Fuel filter