SUOMY MX TOURER Manual De Instrucciones página 25

worn and fastened: the tightness of the strap must only be checked by following the instructions described above.
To unfasten the retention system, release the snap-on button and pull the release tab to release the tightening torque.
Pull out the free end of the strap from the "D-Rings".
RETENTION SYSTEM ADJUSTABLE MICROMETRE
Adjustment
After adjusting the length of the strap ensure that the free end of the strap is correctly positioned in the adjustment buckle (C).
Closing the strap:
There are eight locking positions that allow easy adjustment and closing of the retention system according to the shape of the user's head.
Push the plastic tab (A) into the runner (B) until the strap fully adheres, then press firmly against the jaw. Once it has been closed, pull hard on
the strap to make sure it has locked properly. If you are unable to get a tight fit, adjust the length
of the strap by sliding the belt through the buckle (C). Repeat until you get the retention system is
properly tightened.
Release of the strap:
Detach the plastic tab (A), by pulling the fabric flap (D) located on the tab (B).
Use the release tab only to remove your helmet! Never touch the release tab while riding.
If the release system does not work properly, refrain from using the helmet and contact
Suomy authorized personnel only.
USE and MAINTENANCE
See Figure 2b
B
Eng
B
C
D
figure 2b
23