Use And Maintenance; Retention System - SUOMY MX TOURER Manual De Instrucciones

USE and MAINTENANCE

Eng

RETENTION SYSTEM

The structure of the system may vary depending on the countries in which the helmet is marketed in relation to special certification
regulations.
Adjust the closing system so that, when the helmet is fastened, the strap presses firmly against the jaw and the following conditions occur:
• it must not be possible to remove the helmet
• when grabbing the helmet at the back and rotating it forwards, it cannot be pulled off and remain firmly on your head
If the helmet tends to slip or swivel freely on your head, check the adjustment of the strap until you get the right pressure and try moving it
again.
If after repeating this test you are unable to effectively tighten the retention system, refrain from using the helmet.
"D-RING" RETENTION SYSTEM
Insert the strap's loose tab into the rings. Pull the terminal until the strap presses firmly against your
jaw.
Once you have done this it must no longer be possible to remove the helmet. Check that, by
grabbing the back of the helmet and turning it forwards, it cannot be pulled off and stays firmly on
your head.
If the helmet tends to slip or rotate freely on your head, tighten the strap until you get the right
pressure and repeat the test.
If after repeating the test you are unable to effectively tighten the retention system, refrain
from using the helmet.
Only after checking the correct tension of the strap, attach the free end and lock it onto the release
tab with the snap-on button.
The snap-on button only serves to fasten the free end of the strap to prevent any movement
while riding. The fastening of the release button does not ensure that the helmet is properly
22
See Figure 2a
figure 2a